New KANGLUCHI heater? Get manuals & setup guides →
Product supportGlobal / EN

Safety information

Safety first. Every time.

This page summarizes key safety requirements from the A1 and H1 heater manuals and does not replace the complete manual; read the manual for your model before installation and use: A1 manual or H1 manual (A1 PDF / H1 PDF).

Carbon monoxide & ventilation

  • Provide adequate ventilation around the unit to prevent carbon monoxide poisoning.
  • Route the exhaust outdoors to prevent exhaust gases entering the occupied area.
  • Use the heater only in a well-ventilated area.

Full details in the A1 manual · H1 manual

Fire & hot surfaces

  • Keep flammable materials away from the exhaust pipe and muffler outlet and use insulation for protection.
  • The exhaust pipe becomes extremely hot during operation.
  • Do not heat or ignite flammable items.
  • Prevent direct contact with the H1 heater's outer surface to avoid burns.

Full details in the A1 manual · H1 manual

Fuel

  • A1: Refuel only with diesel fuel that meets national standards; never use gasoline, alcohol, methanol, or other volatile fuels.
  • H1: Use high-quality diesel, not kerosene, vegetable oil, gasoline, waste oil, or other fuels.
  • Turn off the heater before refueling.
  • Do not allow fuel to enter the housing when filling.

Full details in the A1 manual · H1 manual

Power & wiring

  • Do not disconnect power during operation or stop the heater by disconnecting power.
  • A1: Use a 12 V power supply with current of at least 15 A or a 24 V power supply with current of at least 10 A.
  • A1: When extending the power cable, use wire with a cross-sectional area greater than 2 mm².
  • A1: After wiring, wrap all connections with electrical tape.
  • H1: Insulate unused wire ends and use only the original power supply.

Full details in the A1 manual · H1 manual

Shutdown & cooling

  • A1: After turning off the unit, allow 3–10 minutes for the shutdown cooling cycle to finish and the unit to stop completely before disconnecting power.
  • H1: After switching off, allow 3–5 minutes for shutdown cooling and a complete stop before disconnecting power.
  • H1: After switch-off, the fan continues until housing temperature falls below 60 °C or for a maximum of 600 seconds; do not disconnect power during this cycle.

Full details in the A1 manual · H1 manual

Installing it yourself

  • H1 is installed by the buyer. Install it yourself only if you are confident with 12/24 V DC wiring, fuel lines, drilling through the vehicle floor and routing exhaust outdoors. If not, have it fitted by a qualified installer.
  • H1: Mount the heater level on its base, not tilted or on its side.
  • Never drill holes or install mechanical equipment on a wood floor.

Full details in the A1 manual · H1 manual

Who can use it

  • A1: Children are strictly prohibited from operating the unit. Cleaning and user maintenance must be done under guardian supervision.
  • H1: Children aged 8 and over and people with reduced physical, sensory, or mental capabilities, or insufficient experience or knowledge, may use the appliance if supervised or instructed in safe use and they understand the hazards.
  • H1: Children must not play with it or clean or perform routine maintenance without adult supervision.

Full details in the A1 manual · H1 manual

Where not to use it

  • A1: Do not use the heater in spaces used to heat or transport hazardous materials.
  • H1: Do not use where hazardous goods are loaded, unloaded, or transported.

Full details in the A1 manual · H1 manual

Questions? Contact supportDownload A1 PDF manualDownload H1 PDF manual